Hypertherm SensorOHC Manual de usuario

HYPERTHERM SENSOR™ OHC AUTOMATED OXY HEIGHT CONTROL OPERATION & SET UP GUIDE Making people and machin

6 Sensor OHC Operation and Set Up Guide Control Unit Front Height Set Point AdjustSet Up & Calibration Access Panel Power Indicator In

Section 1: Overview 7 Control Unit Bottom Power & Motor Ground Limit Switches Control Interface 6 Amp FuseCapacitive Sensor

8 Sensor OHC Operation and Set Up Guide Sensor and Mounting Isolator Mounting Isolator Spring Breakaway Capacitive Sensor Ring

Section 2: Operation 9 Section 2: Operation Operation Modes The two basic modes of operation are “Automatic” and “Manual”. Note: The control unit

10 Sensor OHC Operation and Set Up Guide Error Conditions Error Indications The red ERROR LED indicates abnormal conditions by flashing an error cod

Section 3: Installation and Set Up 11 Section 3: Installation and Set Up Installation Sensor Mounting The sensor connection is thru the coax cable

12 Sensor OHC Operation and Set Up Guide Connectors Wire the unit as shown with reference to the following figures. A standard mating connector kit

Section 3: Installation and Set Up 13 Limit Switch The lifter upper and lower limit switches are connected to the 9 pin “D” connector. These swit

14 Sensor OHC Operation and Set Up Guide This second external height set point could be useful to provide an independent pierce or preheat height. B

Section 3: Installation and Set Up 15 Standard Wiring Installation MINPIN4REMOTE HEIGHT ADJPIN14PIN2PIN3PIN11PIN8PIN6PIN 6ERROR OUTPUTLOWER LIMI

DISCLAIMER The information in this document is subject to change without notice and should not be construe

16 Sensor OHC Operation and Set Up Guide IO Interfacing The attached figure shows the details of connecting the IO to external switches, relays, tran

Section 3: Installation and Set Up 17 DIP Switch Setup SW1 SW2 SW3 Sensor Cable Length on on on cable length = 500 mm off on on

18 Sensor OHC Operation and Set Up Guide Calibration Procedure Calibration Instructions 1) Install the torch and sensor ring with torch tip aligne

Section 3: Installation and Set Up 19 Component List Optional Sensor Cables Part Number Description CONN-0141 MATING CONNECTOR KIT CABL-0163 A

20 Sensor OHC Operation and Set Up Guide Connector Kit (CONN-141) Components

Printed in the USA MANU-0044

Table of Contents SAFETY ...

Safety 1 Safety Read This Manual Read and understand this instructional manual, the cutting machine manuals, and your employer’s safety practices.

2 Sensor OHC Operation and Set Up Guide

Section 1: Overview 3 Section 1: Overview Introduction One of the most important parameters in Oxy Torch cutting is consistent torch tip to plate

4 Sensor OHC Operation and Set Up Guide Description and Features System Features* Compatible Motors DC shunt 24VDC, 2 Amps to

Section 1: Overview 5 Hardware Specifications Main Power Supply: 24 Vdc +/- 10%, 50/60 Hz Compatible Lifter Motors: DC shunt motor 24Vdc, 2 Am